VMware Cloud on AWS GovCloud (US) 服務

SaaS services
Español 繁體中文

Configure a Layer 2 VPN Tunnel in the SDDC

Specify a local (SDDC) IP address, a remote (on-premises) public IP address, and a remote private IP address to create the SDDC end of the Layer 2 VPN tunnel.
VMware Cloud on AWS GovCloud
 supports a single Layer 2 VPN tunnel between your on-premises installation and your SDDC.
  1. Log in to the
    VMware Cloud on AWS GovCloud
     at https://www.vmc-us-gov.vmware.com/.
  2. Select
    Networking & Security
    VPN
    Layer 2
    .
  3. Click
    ADD VPN TUNNEL
    .
  4. Configure the VPN parameters.
    Option
    Description
    Local IP Address
    • Select the private IP address if you have configured AWS Direct Connect for this SDDC and want the VPN to use it.
    • Select the public IP address if you want the VPN to connect to the SDDC over Internet.
    Remote Public IP
    Enter the remote public IP address of your on-premise L2VPN gateway. For an L2VPN, this is always the standalone NSX Edge appliance (see ).
    Remote Private IP
    Enter the remote private IP address if the on-premise gateway is configured behind NAT.
  5. Tag the VPN.
    如需有關標記
    NSX
     物件的詳細資訊，請參閱
    《
    NSX
     Data Center 管理指南》
    中的〈將標籤新增至物件〉。
  6. Add a
    Description
    .
  7. Click
    SAVE
    .
    Depending on your SDDC environment, the Layer 2 VPN creation process might take a few minutes. When the Layer 2 VPN tunnel becomes available, the status changes to Up.

Content feedback and comments