VMware Site Recovery Manager 8.8

8.8 8.7 8.6
简体中文 Deutsch Español Français Italiano 日本語 한국어 繁體中文 English

Connect the
Site Recovery Manager Server
 Instances on the Protected and Recovery Sites

Before you can use
Site Recovery Manager
, you must connect the
Site Recovery Manager Server
 instances on the protected and recovery sites.
  • Verify that you installed
    Site Recovery Manager Server
     instances at the protected and recovery sites.
  • If you did not select the default plug-in ID when you installed
    Site Recovery Manager Server
    , you must have assigned the same custom plug-in ID to the
    Site Recovery Manager Server
     instances on each of the sites.
This is known as site pairing.
Site Recovery Manager
 does not support network address translation (NAT). If the network that you use to connect the
Site Recovery Manager
 sites uses NAT, attempting to connect the sites results in an error. Use credential-based authentication and network routing without NAT when connecting the sites.
  1. In the
    vSphere Client
    , click
    Site Recovery
    Open Site Recovery
    .
  2. Click the
    New Site Pair
     button.
  3. Select a local
    vCenter Server
     from the list, select a pair type, and click
    Next
    .
    • Pair with a peer
      vCenter Server
       located in a different Single Sign-On domain
    • Pair with a peer
      vCenter Server
       located in the same Single Sign-On domain
  4. Enter the address of the
    vCenter Server
     for the
    Site Recovery Manager Server
     on the second site, provide the user name and password, and click
    Find vCenter Server Instances
    .
    The address that you provide for the
    vCenter Server
     must be an exact match of the of address that you provided when you installed
    Site Recovery Manager Server
     on the recovery site.
    To facilitate IP address changes in your infrastructure, provide a fully qualified domain name (FQDN) whenever possible, rather than an IP address.
  5. Select the
    vCenter Server
     and the services you want to pair, and click
    Next
    .
  6. On the Ready to complete page, review your settings selection, and click
    Finish
    .
The protected and the recovery sites are connected. The pair appears under
Site Pairs
 on the
Site Recovery
 Home tab.

Content feedback and comments